Garage Door Springs Repair

Overhead garage doors are operated through torsion springs, regardless of whether you have one piece swings up garage door or sectional garage door with multiple sections. With the passage of time, these springs will lose their tension and break down eventually due to frequent use. They can be repaired or replaced immediately. It is not such a type of repair which you can do on your own. It is always wise to hire professional garage door repair companies like, Ace Garage Door Repair Company to deal with the garage door.

Since garage door runs on the heavy metal tracks which are attached along to the wall. There are two types of springs such as extension and torsion garage door springs. If you have swung up the garage door, it runs on the horizontal tracks amounted to the wall. The metal tracks should slant down toward the backside of the garage. High-quality and powerful springs are attached on either side of the frame and hooked to the garage door. If these springs are adjusted under required tension, then it is worthy to check the brackets to find out any loose hardware such as nuts, screws, plates, and plates. If yes, simply tighten up the brackets will resolve the issues.

If you have installed a roll-up garage door, its tracks are mounted in a curve from vertical to a horizontal position in order to roll up the garage door on the back of the garage. It also uses torsion spring which is controlled by a cable and pulley system. In this case, you can adjust the spring by pulling the cable or readjusting the knots in order to increase or decrease the length of the garage door cable and imposed a required amount of tension of garage door springs. Remember, if your garage door has one torsion spring mounted at the center of the garage door, it is advisable to call a garage door specialist rather than attempting it on your own to avoid unhappy incidents.

Garage door springs repair

Garage door springs repair and replacement is a challenging job. If you feel that you are able to meet the challenge, ensure that you have got a new spring similar to the old spring in terms of its size, length, and capacity. You should be well familiar with the winding bars and pulleys which will help you to install a new part. Removing the old spring can cause you to release the stored energy, which can give you injuries if you are not properly cautious.

There are a lot of online tutorials available to help you in this regard, but there are some important things that you should keep in mind while dealing with the garage door springs. You should close the garage door completely and disconnect the power supply from the opener then place the ladder to the one side of the working area to avoid the path of winding bards. Make sure that you hold a strong grip on the winding bars to install them into winding-cone or holes on the torsion springs. Be careful because under-winding will make the garage door heavy to operate and over-winding can cause to a bouncy garage door.

If you are not confident enough to safely replace the garage door springs, do not hesitate to call a professional technician. Safety is a major consideration, so it not good to put yourself into danger. In order to avoid costly garage door repair, inspect, fixed, and replaced the damaged garage door parts timely and to keep your garage door in good working shape.